Detangle
Gently remove tangles using a wide tooth comb, working gradually from the ends to the root of the hair.
Wash
Place 3 tablespoons of Shampoo in a bowl or sink and add luke warm water until the sink or bowl is half full. Place one of your hands in the water and gently mix the water and shampoo together.
Hold the unit at the front hairline and gently dip the system in the water,
Submerge the unit in water then take it out - Repeat this process four times.
Drain the shampoo water and replace it with clean lukewarm water
Rinse
Submerge the system in the water then take it out - Repeat this process four times. Place a towel on a flat service; After thoroughly rinsing the system place the system on top of the towel
Condition
Apply a liberal amount of Conditioner. Starting 1 inch from the base of the system, evenly distribute the conditioner throughout the hair system using your finger tips
Warning: Applying conditioner to the base will cause the knots to loosen which leads to excessive shedding
Allow the conditioner to set 30 minutes
Rinse (repeat)
Gently pat and press with a soft towel to remove excess water. Refrain from rubbing, squeezing, twisting or wring hair.
Dry
Place the system on a Styrofoam head and secure the unit with push pins. Gently ly remove tangles using a wide tooth comb, working gradually from the ends to the root of the hair.
Allow the hair to air dry.
Secure the knots
Steal the knot
Turn the unit inside out and apply two coats of Acrylic spray or knot sealer
Allow the treatment to dry and you are ready to re-apply your system.
